New Digital Measurement Improves Part Processing & Productivity.
| Model | DPG150 Full Cover |
|||||
| Digital Projector |
Screen Size (W x H) |
32 inch Monitor | ||||
| Magnification | Normal/High | Max 110/400 | ||||
| Illumination |
LED Lighting |
Bottom (Diascopic) | Digital Dimming V/W | |||
| Top (Episcopic) | Digital Dimming V/W | |||||
| Table |
Working Surface (Sub Table) | 400 x 250 mm | ||||
| Height Up To Focus Point (Table Sub Plate Exclude) |
60 ~ 185 mm | |||||
| Travel |
Traverse Feed (Z-Axis) | 300 mm | ||||
| Cross Feed (V-Axis) | 150 mm | |||||
| Vertical Feed (A-Axis) | 125 mm | |||||
| Feed Speed |
Rapid Feed (G0) | 2000 mm/min | ||||
| Grinding Feed (G1) | 0.1 ~ 1000 mm/min | |||||
| Wheel-Head |
Linear Axis | Travel |
Traverse Feed (X-Axis) | 200 mm | ||
| Cross Feed (Y-Axis) | 150 mm | |||||
| Feed Speed |
Rapid Feed (G0) | 1500 mm/min | ||||
| Grinding Feed (G1) | 0.1 ~ 1000 mm/min | |||||
| Relief Angle |
Amount |
Radical Direction of Wheel | -2~ 20° (manual *option_electric) | |||
| Axial Direction of Wheel | ±15° (manual *option_electric) | |||||
| Swivel Slide Swiveling Angle |
±15° (manual *option_NC) | |||||
| Reciprocating Slide |
Reciprocating Stroke Range |
0 ~ 155 mm/crank motion *linear motor | ||||
| Reciprocating Speed |
30 ~ 400 min-1 *by quantity of going up and down lifting, there is a limit |
|||||
| Wheel Spindle |
Wheel Size |
High-Speed Type |
65 ~ 100 x 4 ~ 6 x 22.23 mm | 75~100×4~6×22.23mm | ||
| Low-Speed Type | 120 ~ 180 x 3 ~ 10 x 31.75 | – | ||||
| Rotation Speed |
High-Speed Type | 2000 ~ 20000 (TC-20) min-1 *selection specification | 2000 ~ 20000 | |||
| Low-Speed Type |
1000 ~ 6000 (TS-6) min-1 *selection specificaion | _ | ||||
| Machine Gross Weight |
Half Cover | Full Cover | Full Cover with Robot | |||
| 4500 kg | 5000 kg | 5000 + 500 kg | ||||
| Noise Level |
Less than 70 dB | |||||
| Power Size |
18 kVA | |||||
| Air Pressure / Air Delivery |
More than 0.6/300 Mpa/NI/min | |||||
Specifications and the machine design may change without notice at the sole discretion of Amada’s Engineering Department.
Contact for repair and recovery of AMADA products and our corporate activities.
