When cutting a large plate with a smaller diameter cutter, it requires multi-pass cutting, and when the cutting-pass is increased, the machining time becomes even longer. Also, the multi-pass cutting can leave ridges between the cutting tracks, which requires highly skilled programmers to run the machine.
This machine is equipped with a large ” ( mm) diameter cutter, which enables the one-pass cutting of up to ” ( mm) in width, eliminating the ridges that are made with cutting with the smaller diameter cutter.
|Body||Index Table Size|
|Max Longitudinal Travel (X-Axis)|
|Max Cross Travel (Y-Axis)|
|Max Vertical Travel (Z-Axis)|
|Distance from Insert Edge to Table Surface|
|Inside Distance Between Two Columns|
|Capacity||Max Material Dimensions (W x L x H)|
|Face Mill Cutter Diameter|
|Table Loading Capacity (Workpiece + Magnetic Chuck)|
|Feed Speed||Rapid Feed Speed (X & Y-Axis)|
|Rapid Feed Speed (Z-Axis)|
|Cutting Feed Speed|
|Spindle Speed (Optional High-Speed Spec.)|
|Max Spindle Torque|
|Spindle Motor (AC Spindle, 50% ED/cont.)|
|Feed Motor (X-Axis) (AC Servo Motor)|
|Feed Motor (Y & Z-Axis) (AC Servo Motor)|
|Spindle Lubricant Pump|
|Spindle Surface Lubricant pump|
|Machine Dimensions (W x L x H) (without safety fence)|
|Spindle Lubrication Oil Tank|
|Spindle Surface Lubricant Oil Tank|
|Air Pressure Requirement|
|Electric Power Requirement|
Specifications and the machine design may change without notice at the sole discretion of Amada’s Engineering Department.
TWO-FACE PLATE MILL
Contact for repairand recovery of AMADA products and our corporate activities.