SA330WPC

Download Brochure & Specification Sheet

Hydraulic Down Feed
- Feed rate and down pressure can be controlled for fast, accurate cutting. Setup is made easy through the color-coded dial allowing the operator to select the optimum setting for the type of material being cut. Both settings are made at the operator’s station.
Hydraulic Shuttle Feed
- Length settings of 0-27.56” (0-700mm) are accomplished with simple programming at the operator’s touch screen. The shuttle comes to positive stops at both ends of the index, assuring cutoff length accuracy, reducing material loss. Repeatability is + .005” per index.
PC Programmable Control
- Conveniently located on the operator’s control panel, this touch screen control allows the operator to program and store up to ten jobs. Inputs include Part Length from 0-999.999” and the Number of Pieces to be cut. The Blade Speed is displayed on and set using the touch screen but is not stored in memory. The Automatic Piece Counter stops each job when the pre-set number of cuts has been made.
Out-of-Stock Switch
- The machine will shut off automatically when the material is no longer present in the rear vise jaws, allowing for truly automatic operation.
Full Stroking Hydraulic Vise Jaws
- Hydraulic vices hold the work piece, providing accurate cuts and longer blade life.
Shuttle Vise
- The shuttle vise jaw floats hydraulically to accommodate crooked stock assuring straight, accurate cuts. The remnant length is 9.5” (241 mm).

Model		SA330WPC
Cutting Capacity	Round (Diameter) at 90°	13″	330 mm
	Round (Diameter) at 45°	11″	280 mm
	Rectangle (W x H) at 90°	16″ x 13″	406 x 330 mm
	Square at 90°	13″ X 13″	330 x 330 mm
	Rectangle (W x H) at 45°	15″ x 15″	380 x 380 mm
Work Load Capacity
Saw Blade	Blade Size (L x T x W)	13’7″ x 0.035″ x 1″
	Blade Speed	95-295 SFPM	29-90 m/min
	Tension Control	Hydraulic
Blade Control	Top Limit Setting	Manual Setting
Blade Control	Cutting Control	Hydraulic Flow Control Valve
Vise Operation	Type	Main and Rear Vise
Vise Operation	Control	Hydraulic Full-Stroke Cylinder
Motors	Saw Blade	5 HP	3.7 kW
	Hydraulic Pump	1/2 HP	0.37 kW
	Cutting Fluid Pump	1/8 HP	0.06 kW
Power Requirement	Power Supply Voltage	AC230V±10%, 3 PH, 60 Hz, Required at Factory Voltage Setting
Power Requirement	Power Requirement
Cutting Fluid	Tank Capacity	14.5 gal	55 liters
Hydraulic	Tank Capacity	4.0 gal	15 liters
Hydraulic	Pressure Setting
Chip Disposal		Chip Conveyor
Material Index	Index Mechanism	Shuttle Vise
	Stroke	15.7″	400 mm
	Length
	Number of Input Block/Station
	Number of Cut-Off Pieces
	Remnant Length
Machine Dimensions (W x L x H)	Head-Up Position	110.5″ x 94.3″ x	2807 x 2395 x
Machine Dimensions (W x L x H)	Head Down Position	110.5″ x 94.3″ x 65.5″	2807 x 2395 x 1665 mm
Table Height		27.6″	700 mm
Machine Weight		3,175 lbs	1,440 kg

Specifications and the machine design may change without notice at the sole discretion of Amada’s Engineering Department.

Contact for repairand recovery of AMADA products and our corporate activities.