VT4555 (8-Mark-II)

Download Brochure & Specification Sheet

Front Mounted Speed Control
- Allows blade speed to be adjusted from the operator’s control station.
T-Slotted Work Table
- Work area 24.25” x 33” (616 mm x 838 mm); table height 34.5” (876 mm); four machined T-slots accept .625” (15.5 mm) T-Bolts.
0 – 3° Canted Column
- The canted Column is not adjustable and is available in either 0° or optional 3° Cant.
Miter Cutting
- Column and blade tilt up to 45° right and left.
Quick Action Vice
- Maximum opening 18” (457 mm). Jaws can be shifted to either right or left side of the blade. Jaws are 6” (152 mm) high, 12” (305 mm) wide.
Flushing Hose
- Washes chips from hard to get at places reducing clean-up time.
Power Chip Brush
- Together with blade wipers and flood coolant deep blade teeth free of chips.
Eagle Beak VTR Blade
- Eagle Beak VTR blade with 3/6 tooth pitch. This is the standard blade that is included with machine purchase.

Model		VT4555
Cutting Capacity (Standard Column)	Round at 0° (Diameter)	18″	457mm
	Round at 45° (Diameter)	12.75″	324mm
	Rectangle at 0° (W x H)	18″ x 22″	457 x 560 mm
	Rectangle at 45° (W x H)	18″ x 12.75″	457 x 324 mm
	Maximum Vise Opening	20.0″	500 mm
Work Load Capacity		4996 lb	2267 kg
Saw Blade	Blade Size (L x T x W)	14’6″x 0.035″ x 1″	4420 x 0.9 x 27 mm
	Blade Speed	50-450 ft/min by Inverter	15-137 m/min by Inverter
	Tension Control	Pneumatic (tightening by air ratchet)
Blade Control	Cutting Control	Clutch power feed
	Blade Feed Force	0 to 140 lbs	0 to 620 N
Motors	Saw Blade	5 HP	3.7 kW
	Cutting Fluid Pump	1/8 HP	0.1 kW
	Tilt Gear Motor	1/15 HP	0.05 kW
Power Requirements	Power Supply Voltage	AC230V +- 10% or AC 460V +- 10% 3PH, 60Hz, Required at factory voltage setting
Power Requirements	Power Requirement	9.3 kVA
Cutting Fluid	Tank Capacity	19.8 gal	75 liters
Cutting Fluid	Pump Type	Electric
Air Supply	Air Supply	87 – 145 psi	0.6 – 1.0 MPa
Air Supply	Air Set Pressure	80 psi	0.55 MPa
Chip Disposal		Manual
Machine Dimensions (W x L x H)		52.64 x 94.4 x 84.5	(1337 x 2396 x 2146 mm)
Table Height (Above Floor)		34.5″	876 mm
Machine Weight		2867 lbs	1300 kg

Specifications and the machine design may change without notice at the sole discretion of Amada’s Engineering Department.